Tractor Talk Discussion Board |
Re: Marvel Schebler Carb
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bob (KY) on June 28, 2000 at 19:44:56 from (63.27.112.253):
In Reply to: Marvel Schebler Carb posted by Dan on June 28, 2000 at 18:28:14:
Dan, I just went thru this with my carb (same brand). I took apart and thought that I had opened EVERY orfice in it and still the carb wouldn't work right. I followed some advice from a 50 year ford mechanic on the N board. He suggested using cleaning tips for blow torches. I did this and blew all holes out with compressed air. Be sure all parts are clean. Set the float at 1/4" from the nearest edge of float to the face of the gasket. After you assemble the carb, adjust the air mixture screw 1 turn out. Set the main jet screw at 1 turn out. The idle speed screw should be adjusted 1 1/4 turns. You should be able to start the tractor at these settings. After engine is warmed up, open throttle all the way and adjust the main jet out till engine sputters or runs rough. Slowly turn the main jet screw back in till engine just begins to sputter and then screw out 1/3 turn. This will adjust the high speed. Now, with engine at idle, screw the air mixture screw in until engine starts to miss, then screw back out until the engine runs smooth. At this point adjust the idle speed screw to get desired idle. The main thing is be sure that all orfices are open when you clean the carb. The cleaning tips worked great and you can get them for $3- $4. GOOD LUCK
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|