Posted by the tractor vet on February 25, 2009 at 10:07:05 from (75.19.120.250):
In Reply to: leaky axle/Ford truck posted by jay-eye-see on February 25, 2009 at 09:45:15:
Also i should have told ya that you do not have to drop the ft.end to replace the crush spacer . You remove the yoke and the seal , then you remove the ft. bearing and the crush spacer will be behind the ft. bearing . You remove the crush spacer and replace it then put the ft. bearing back in then the seal then the yoke then the nut . Then it will take X amount of ft. lbs. of torque to get the spacer to start to crush . When it does you put a inch lbs. torque wrench on the nut and you see what you have . This is to be done with the axles out to get the correct reading and you tighten up the pinion nut till you reach the setting . Then it is sorta fixed till the next time. So you tighten and check . More then likely you will need two torque wrenches one inch pound and one foot pound and the foot pound will likely be one that will have to go over 300-400 ft. lbs. So here it may be cheaper to let the dealer install that seal.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Engine Valves - Some Helpful Information - by Staff. Intake - On the intake stroke the piston moves doward, sucking in carburized fuel through the open intake valve. Exhaust valve is closed. Compression - With both the intake and exhaust valves closed, the pistons upward stroke compresses or squeezes the fuel into the combustion chamber. Firing - Ignited by the spark, the compressed fuel explodes and forces the piston downward on its power stroke. Intake and exhaust valves are closed. Exhaust valves and seats are exp
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.