Oil pressure guage. Probably zero to 150psi fsd. Oil pump. Pressure relief valve. Oil level in sump. Did you prime the oil pump before turning it over?
Remove plugs, oil valve gear (or even remove push rods to reduce loading in cam area) and cylinders, fill oil gallery and tow at a good 'engine turning' speed. Plugs removed will allow it to turn easily with no load on the bearings
Get oil pressure before trying to start it. --------------------- As a last resort!! Never needed to do it myself but you could even flood the sump with oil to above the oil pump and crank the engine SLOWLY to get oil flow. Then remove the excess oil before trying to turn the engine fast with the crank splashing in oil - liquids are not compressible!! --------------------- Then get that timing right, change the leaky pump, fit a piece of string or wire to the choke butterfly, replace push rods (if removed), fill the cooling system with hot water, dry those plugs with a torch, pop them in and go at a good tow speed - to try to start it on the main jet (faster than the idle jets in the carb).
When it starts, keep it going at a good rpm until hot, adjust for main jet metering then lower the revs to a little over tickover and play with the slow running needle, gradually lowering the revs until you have the slow running side and the main power jets sorted/balanced.
Of course, check for leaks, continuing oil pressure, nasty sounds, temperature, etc while you are doing all this. It should now be well hot and ready to tighten down the head gasket.
While still hot, loosen each bolt in turn by about 90 degrees and re-torque to full tightness. Do this for each of the head bolts in the tightening sequence given for the head. You might want to do it a second time later after some more running. Reset valve clearances as these will have been reduced a the head is pulled down tighter.
Should go if manifold is good, no air leaks and carb is somewhere near base settings.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: The Saga of Grandpa's Tractor - by The following saga is from the Tractor Talk Discussion Forum. Someone. The saga starts with the following message: Hey guys I have a decision to make. I know what you all will probably suggest and it will probably agree with me way down inside, but here it is. I have a picture blown up and framed in my "tractor room" of a Farmall M. It was my Grandpa's tractor, of which whom I never got to meet. He froze to death getting this tractor out of the barn to pull a truck out of the ditch before I was born. Anyway my dad and aunt had to sell it at the auction,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.