Posted by Don-WI on February 19, 2009 at 17:05:24 from (72.135.123.231):
In Reply to: Re: Today's picture posted by Mike M on February 19, 2009 at 13:02:48:
Next to our barn used to be pretty sloppy so some of the cows would drag their udders- The first time Dad had 2 loads of gravel screenings brought in, but then a few years later the slop hole moved over a little bit farther down.
I had 2 loads trucked in then to fill it in again as a mother's day and father's day present for Mom & Dad. Hasn't been a problem yet, but next to that is starting to get a little soft at times. Don't think it'll be as bad of a problem though.
I know in years past Mom & Dad have gotten plaques for keeping the SCC #'s low. They got another farmer's quality report by mistake a couple 2 years ago and they just about had a heart attack seeing such high numbers till they noticed it was someone elses. Didn't think the #'s went up so high.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.