Posted by Janicholson on February 14, 2009 at 08:43:29 from (64.83.193.190):
In Reply to: 1947 Farmall M posted by Bruce Alt on February 14, 2009 at 07:23:30:
Clarkbug is on to it. The components that turn when the clutch is out in neutral are the front input shaft bearing, the intermediate (input to output shaft) bearing, the constant mesh gear on the input shaft, the costant mesh driven gear on the countershaft, the countershaft, and all the gears on it. The countershaft bearings, the Liftall drive shaft, and reverse idler. I would put a wooden stick about 1/2"diameterX2'long to my ear (or an automotive stethescope) and touch the various internal parts to hear a bad bearing while turning it by hand. My guess is also a broken component getting into the gears. Draining the oil and using a magnet in the bottom will help. Also looking at every tooth on every gear. Best of luck, JimN
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.