Posted by NE IA on February 14, 2009 at 05:51:25 from (206.72.18.153):
Yesterday I used muradic acid to clean a fuel tank, Totaly unbelievable results in a hr or less. It looks better than the day it was made. I've used sand blasters, cement mixers, vinager, rocks & bolts over the last fourty years with decent results. Never again will I mess with the other stuff.
I know this issue has been addressed before, but my skills for finding things isn't my strong point at all.
So once I get it clean and I drain the liquid out, how do I keep the tank from flash rusting? I keep thinking of Phosperic acid, but I'm not sure.
Has anyone had any problems with Red coat for coating the tank after cleaning?
I'm also hoping this doesn't turn into a political post as most of them do. Just kiddin
Thanks everyone, maybe I will remember where I left my memory some day.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.