Tractor Talk Discussion Board |
JD 830 PTO lever problem
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Tom Wyble on June 08, 2000 at 08:29:34 from (208.140.33.201):
I recently purchased a JD 830 diesel tractor. After using it a little I noticed the lever that should disengage the PTO does not disengage it. It feels like there is nothing attached to the lever. The parts manual shows a pretty simple assembly that has a pin that holds the lever to the shaft it should rotate. I'm guessing that this pin broke? Anyone know how big a job it is to open the top of the tranny area to get at that? The tractor also has some problems with the hydraulics. The 3 pt slowly lowers even when running and the power steering works turning to the right but only works now and then when turning to the left. Any insight into these problems and the amount of work and $ to fix them would be greatly appreciated. Tom in western NY
Follow Ups:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|