Welcome! Please use the navigational links to explore our website.
PartsASAP LogoCompany Logo (800) 853-2651

Shop Now

   Allis Chalmers Case Farmall IH Ford 8N,9N,2N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 
Marketplace
Classified Ads
Photo Ads
Tractor Parts
Salvage

Community
Discussion Forums
Project Journals
Your Stories
Events Calendar
Hauling Schedule

Galleries
Tractor Photos
Implement Photos
Vintage Photos
Help Identify
Parts & Pieces
Stuck & Troubled
Vintage Ads
Community Album
Photo Ad Archives

Research & Info
Articles
Tractor Registry
Tip of the Day
Safety Cartoons
Tractor Values
Serial Numbers
Tune-Up Guide
Paint Codes
List Prices
Production Nbrs
Tune-Up Specs
Torque Values
3-Point Specs
Glossary

Miscellaneous
Tractor Games
Just For Kids
Virtual Show
Museum Guide
Memorial Page
Feedback Form

Yesterday's Tractors Facebook Page

  
Tractor Talk Discussion Board

Re: Plow for Farmall 1206


[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]

Posted by Grove r on June 06, 2000 at 18:33:13 from (161.184.18.239):

In Reply to: Plow for Farmall 1206 posted by Jim Frediani on June 04, 2000 at 04:59:21:

There are two basic types of plows, fast turn, or stubble bottoms, and slow turn, or sod bottoms. the stubble bottoms have the share at a more aggresive angle to the ground, and the molboard is shorter with less curve, this configuration lets you travel faster, the material being turned is thrown to the gound harder and more straight down having a shattering effect which makes for less after tilling. I have a four sixteen Oliver plow with stubble bottoms that I pull with ease at six plus miles per hour in stubble and it does an excelant job,[the soil here is sandy clay, and I use an 806]. In sod, this plow pulls like a cat by the tail across the carpet, [just an expression],and the best speed is about four mph. Sod bottoms have a flatter share and a longer more curving molboard. Traveling too fast with these will toss the furrow too far instead of turning it over and laying it flat. These plows are patterned after the bigger and heavyer breaking plows. Their designs are very much the same because they cut roots and have to turn an unbroken strip of material. Of course all plows are not created exactly alike, and there are lots of differnt designs, the two types mentioned are more notably the extremes in designe with lots af variations in between. Hope I haven't confused or discouraged you in any way, this was not my intent .The plow is one piece of farm machinery that is probably the most missunderstood. Properly hitched with sharp shares and used for the conditions it was designed does not pull hard at all, but the extra power you might have is not at all detrimental, better too much than not enough. wishing you every success in your new indeavers G.


Follow Ups:




Post A Followup

:
:

: Re: Re: Plow for Farmall 1206

:

:

:

:

: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.


TRACTOR PARTS TRACTOR MANUALS
We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

Home  |  Forums


Today's Featured Article - Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and ... [Read Article]

Latest Ad: Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request [More Ads]

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters

Website Accessibility Policy