Tractor Talk Discussion Board |
Re: Re: Splitting A Tractor
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Dave Neubert on June 06, 2000 at 14:42:39 from (205.188.196.28):
In Reply to: Re: Splitting A Tractor posted by G. L. Perry on June 06, 2000 at 02:41:24:
I use a floor jack under the front half and put blocks on both sides of the front axle to keep it from pivoiting. If you have a tractor with a narrow front end I use a engine hoist [cherry picker] and attach a sling higher up to make it stable. block the rear tires or lock brakes and move the front away. the long bolts or studs work good to line it up when goging back together.If you have to take clutch apart be sure it is lined up.Do not use long bolts to force it together.If lined up it should go together within a half inch. then if it is not perfictly lined up put a little tension on it and turn motor over by hand ann the pilot bearing should line up and go together the rest of the way. Take your time and dont force it it is not that hard.Concrete is the best to do it on. If not avilable find a level area and put plywood or a metal plate down to work on.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Engine Rebuild Kit - by Curtis Von Fange. I always liked engine rebuild kits. They have all the replacement parts for overhauling an engine without going to the store to get gaskets, special measuring tools, or miscellaneous parts. They come neatly packaged, clean and tidy. But it's important not to let that packaging lull you into a false sense of security. The appearance of matching sleeves, pistons, rings, and bearings can cause frustration and agony if not properly measured and installed in a workshop environment. Following c
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|