Posted by Steven f/AZ on February 05, 2009 at 07:29:42 from (216.67.213.217):
In Reply to: OT - Building a house posted by dr darren on February 04, 2009 at 16:52:25:
Get all the changes in WRITING! Signed by all parties. It does not matter how good of friends you are or how long you've known them, get it in writing and do NOT take their word for it.
Spend the money for upgraded plumbing fixtures, we went with Moen and are very happy that we did. Also, spend the money for high quality ceiling fans. The contractor put in Harbor Breeze and 4 out 5 have died by making a horrible racket and smelling hot. We had 2 replaced with new HB fans and those only lasted a couple months as well. I have replaced 3 out of the 5 with Hunter now and they are quieter than whisper quiet and don't wobble, either!
Spend the money for extra insulation! If you plan on trying to sleep while someone else is in the kitchen or living room watching TV, check into sound insulation. For some reason the sound goes right through the walls in our house...
Make sure the house is wired for cable TV, internet, phone lines, alarm system, etc. It is much, much cheaper to do it now than later. Might want to check into the cost of fiber-optic...
Make sure there are outlets where you need them, too - again much cheaper now than later.
ABOVE ALL ELSE - BE THERE WHEN THEY ARE BUILDING! Make sure they are actually following the plan and/or changes you've made to the plan. There were several instances where if I hadn't showed up that day our house would have had doors in the wrong place, appliances in the wrong place, etc.
No matter how hard you try, once you move in you will think of changes.
Here's our house, completed January of 08:
This post was edited by Steven f/AZ at 07:34:40 02/05/09.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Engine Valves - Some Helpful Information - by Staff. Intake - On the intake stroke the piston moves doward, sucking in carburized fuel through the open intake valve. Exhaust valve is closed. Compression - With both the intake and exhaust valves closed, the pistons upward stroke compresses or squeezes the fuel into the combustion chamber. Firing - Ignited by the spark, the compressed fuel explodes and forces the piston downward on its power stroke. Intake and exhaust valves are closed. Exhaust valves and seats are exp
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
