Posted by fergienewbee on February 05, 2009 at 01:02:15 from (205.188.116.74):
In Reply to: OT - Building a house posted by dr darren on February 04, 2009 at 16:52:25:
We used 2 x 6s @ 24" on center for the exterior walls with 6" batts. The trusses fall above a stud rather than in between when 16" o.c. Get "energy heels" on the trusses. They stand a bit taller at the wall so you can get ventilation. We put 12" batts in the roof. We had a contractor rough it in and subbed out what I couldn't do. I wish I had put the wiring on the print--makes it easier to trace an electrical problem. Buy the best windows you can afford.
We looked at geo-thermal but couldn't justify the cost. With an open loop water is pumped into a pond or into a ditch. With mostly sand, a pond was out. A closed system would have required lots of tubing and estimated at around $25,000.
Take pictures as the build progresses. Nice to look back and see it all come together.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: The Saga of Grandpa's Tractor - by The following saga is from the Tractor Talk Discussion Forum. Someone. The saga starts with the following message: Hey guys I have a decision to make. I know what you all will probably suggest and it will probably agree with me way down inside, but here it is. I have a picture blown up and framed in my "tractor room" of a Farmall M. It was my Grandpa's tractor, of which whom I never got to meet. He froze to death getting this tractor out of the barn to pull a truck out of the ditch before I was born. Anyway my dad and aunt had to sell it at the auction,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.