Posted by ScottyHOMEy on February 04, 2009 at 09:42:06 from (64.222.201.63):
In Reply to: super a cooling help posted by miller farms on February 04, 2009 at 09:14:59:
Not sure what you pulled out there, friend. First thought is that if it threaded out, it ought to thread back in???
Some SAs had water pumps, most did not. The intended drain for the system was a plain old 3/8" pipe nipple about 4 inches long threaded into the bottom of either the pump or the inlet casting, whichever you have, that then passed down vericcally through a hole in the front casting so you could get to it and it would drain to the ground. It was closed by a cap (not a plug) on the bottom end.
Trick is, with field repairs and alterations made over the years, you're apt to find just about anything there for hardware. The original cap on that pipe nipple had Mickey Mouse ears, like a wingnut, on it. That often got replaced with a plain pipe cap. If that's wehere you're working, you might also find a 3/8" pipe plug either in a union wound onto the lower end of the pipe,or, if there's no pipe at all, a pipe plug directly into the drain outlet on the bottom of the pump or inlet casting.
A more challenging scenario is that somebody may have just wound a machine bolt into the tapered pipe thread and got it to seal, but buggered the threads in the process, which would explain your difficulty in getting it back in.
Bottom line, if nothing's broken, the only place that removing one plug or cap that should drain the coolant is from whatever plumbing parts you find on the underside of that pump or inlet.
If you pulled something else, come back and let us know, and one of us can help figure out where you are and what you need to do next.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Day Mom Drove the 8N - by Brian Browning. My Dad was wanting to put in a garden but couldn't operate the 8N and handle the old horse drawn plow he had found and rigged up to use with the tractor. Well, he decided to go get Mom out of the house and have her drive the tractor while he walked behind the plow. You got to understand that while my Mom is a hard worker who will always help whenever she can... she had never operated farm machinery before that day. Dad got her out there, explained how the clutch was the same as in our o
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
