Posted by Paul in MN on February 02, 2009 at 20:04:46 from (207.224.92.218):
In Reply to: Re: old car posted by Hoss in Me on February 02, 2009 at 18:01:30:
My Dad had one of the 51 Chrysler New Yorkers with that first hemi. He put 6 ply truck tires on it to carry the weight. In 1960 he was frequently driving from St Paul MN to Milwaukee WS on Friday nights after he was done at the Sperry Univac plant. The 94 freeway had not been built yet, so it was mostly old 2 lane US highway 12. One evening as he was just east of St Paul, and "leader of the pack" a MN State Patrol decided to take the whole string of cars down for speeding. The ole man was a bit tight, didn't want to contribute to the local fund and got in a race with the State patrol and beat them to the Wisconsin border at Hudson. At that time our family lived in Milwaukee, and it was my job to check out the car on Sat morning so he would have a good trip back on Sunday night. I opened the hood to check the oil and the underside of the hood and much of the engine was covered in oil. I woke the O.M. up at about 10:00am and said "Dad you must have blown some gasket, we'd better find out which one and get parts before they close at noon." Naw, he said, just fill up what is needed. I pressed him about his too casual attitude about oil loss, and he finally came out with the chase story, figuring he was hitting 120 to 130 mph. Not many cop cars at that time could beat a hemi, and their radios weren't very good then either. Normally the O.M. was 100% law abiding and wanted us boys to be exactly 100% law abiding. Learned something about the old man that morning!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
