Easy answers first, I'm 12 miles south of Frankfort on US 127. Right on the Anderson Mercer County line, or thats where I am normally. Im snowed in tonight on the laptop a tad east of there, lol.
The hitch I can tell you from memory, but I sold the rake :( to a guy just down the road a ways. I built it with what I had, pc of 4 inch square tubing that was a foot longer than the width of the rear wheels. I used 18 inch long, 2 pc, of 4 inch C channel bolted to the frame where the tubing would just clear the tires. Then welded it on the bottom of the C channel. Then I used a pc of 3 inch thick wall square tubing inside the 4 inch. Its length, retracted, was even with the outside of the basket on the left side. Then I pulled it out and drilled through both pieces to anchor it retracted, 4 feet out, and 7 feet out. I used some 2.5x 3/8ths flat steel that stuck out 6 inches when welded on the 3 inch square tubing. I designed it as I built it, and have built a few others over the years.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - History of the Nuffield Tractor - by Anthony West. The Nuffield tractor story started in early 1945. The British government still reeling from the effects of the war on the economy, approached the Nuffield organization to see if they would design and build an "ALL NEW" British built wheeled tractor, suitable for both British and world farming.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
