Posted by jd b puller on January 14, 2009 at 17:14:28 from (65.87.162.161):
In Reply to: Denial? posted by farmer boy on January 14, 2009 at 16:48:11:
Spook said: (quoted from post at 21:53:24 01/14/09) Yup, but if you have a date, and a "number", that you are planning on, either that dates gotta move out, or the number has gotta get smaller.
Spook, look at it like this...as long as your planned retirement date is AFTER the market recovers, you're in the good.
Let's say you have $500,000 invested with an average share price of $100/share - you have 5000 "shares".
Now, the market takes a crap like it did, you now have $250,000 - but you still have 5000 "shares".
Now, when you buy, you are buying at the "sale price", so you buy more shares. Nobody knows how long this market will stay like it is, or how it will "recover", but if you assume it stays like this for a while, the longer it stays low, the more you can buy. When your friend says "recover", I'm assuming he means that the market would recover to teh 2008 level adjusted up for inflation/increase. At that point, since you have more shares and the value of the shares is now what it would have been, you are "ahead" of the steady 4-6% you were gaining (2 years ago I was +27%, last year it was -42%).
Except for the struggle of watching your accounts dwindle, and the frustration of realizing that it took you 10 years to accumulate that money and 10 months to lose 1/2 of it. I'm still ok with it. If you're 5 years from retirement, you might want to rethink that date. I'm 15 years away.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.