Or, without any big govt interference or zoning at all - there wouldn't have been any issue at all.
The other side of the coin. :)
I know, with no zoning at all we run into the 'bad neighbor' issues and that is no good either.
Just for the argument - your point seems to be that the early zoning was good to protect you from the later zoning.... But, if there were less zoning at all, then there would not have been any past or present issues for your grandma at all. Your arguement does not support a lot of zoning & government being a good thing.....
This is not an issue with you - I like to debate these issues on their merrits, not on the personality. I know we are in for more & more & more govt regulation, and the govt bodies keep telling us it is for our own good, it will make life so much better for us.
All it does is drive up insurance costs, fees, taxes, and the cost of doing business, and drives jobs over to other countries. Why does business move to China & Mexico? 'Zoning laws' and their costs and hassles are a small part, as your grandma found out, just makes doing anything in this country cost more. It is easier to sell a few parts out of an old barn in a country with less zoning laws.
If your grandma lived in _my_ county/state, she will find out the very bad _negatives_ of that zoning ruling if she ever tries to add on or rebuild the house............. Oops, not a residential, can't do that.
You are proving that zoning laws are a major hassle, not that they are a good deal.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.