Tom there is at least one way to do this economically but it all depends on the person on the seat otherwise it can cause major damage to pto machines. First of all what size 1000 pto shaft do you have? Tractors such as the MF2805, AC7080 and the 4840Deere any tractor above 160hp pto hp have larger splines once that is found you can get a 1000 to 540 adapter now you can use a hand tach and adjust your throttle to achieve something a little above 540rpm I'm thinking 575rpm I don't have the Dyno chart anymore that set the rated rpm before test. You can even do that with the neighbors tractor at their tach rated rpm adjust your throttle to achieve the output speed then mark your tach at that not to exceed position now the operator comes into play because you will have to have the disipline to not throw the throttle full forward while starting up the baler. If you have someone else running the baler you may have to use some ingenuity to put a mechanical stop on the throttle. It all works I've done it with things like haybines, manure spreaders and square balers, I have not tried it with forage harvesters because of the tractors rpm torque rise range due to varying loads.If I remember right IH wouldn't guarantee their double pto option above 100hp anyway but there were many 10's and 14's with them anyway. Good Luck CT
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: 1951 Farmall H - by The Red (John Fritz). I have been a collector of Farmall tractors since 1990 when I first obtained part of the family farm in Eastern Indiana. My current collection includes a 1938 F20, 1945 H, 1946 H, and the recently purchased 1951 H. This article will focus on what I encountered and what I did to bring the 1951 NEAR DEATH Farmall H back to life.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
