Posted by jdemaris on December 14, 2008 at 14:33:54 from (67.142.130.23):
I outdid myself today when it comes to making stupid mistakes.
Power has been out around here now for three days. No problem at my own home since I've got solar electric, battery banks, etc. But, my neighbor up the road asked for some help via my PTO generator. Well, I hadn't used it in years. And, all my wheel tractors are already hooked to something and I didn't feel like taking stuff off. So, I pulled out my little Cletrac HG dozer and hooked the Generac 17 KW PTO generator to it. I've used it this way before and it ran it just fine (many years ago).
Drove it up to my neighbors as-the-crow-flies though our fields. Hooked to his house, engaged the PTO - and nothing. Voltmeter read just about zero. I'm sittting there scratching my head, trying to think what could be wrong. Then got thinking the generator might have mechancial regulators that got stuck - so I started kicking it. That did not work. Then my neihbor asks if my PTO is turning slow. I looked closely and it seemed to be turn maybe 2 revs per second - i.e. 120 RPMs? Then, it dawned on me. I installed a 3 speed aux. trans in the Cletrac years ago, and kind of forgot about it. It works so nice in low range - it never gets shifted into anything else. Well, I really felt like an idiot - especailly since I'm the one that built the swap-deal in the first place. So, put the aux. into third gear (1 to 1 ratio) and the generator worked perfect. I have to admit, that even the stuff I've built myself confuses me when I haven't used it in awhile. Sun was just going down when we got things going.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
