Tractor Talk Discussion Board |
Re: Re: Re: Is there a hyd valve for UP,HOLD,FLOAT, and DOWN?
[ View Follow Ups ] [ Post Followup ] [ Return to Tractor Talk Discussion Board ]
Posted by Dan from PA on April 08, 2000 at 02:07:29 from (151.201.75.31):
In Reply to: Re: Re: Is there a hyd valve for UP,HOLD,FLOAT, and DOWN? posted by Greg Reuter on April 07, 2000 at 18:08:14:
If you're starting from scratch, make sure the valve has a built-in relief valve. Or buy one seperately. Depending on the pump, it may bypass, but will more likely bend/slip/break/strip or (worst of all) explode something. You'll also need a resevoir (with breather) and filter. Make sure your suction line to the pump is of adequate size so it doesn't suck shut and starve the pump. Also, make sure there is enough oil covering the suction line inlet that a vortex does not form, causing air to be drawn into the pump (check at max cyl extension). Further research revealed that load checks are to prevent movement of the load while switching valve position. Yes, 4-way valves w/float have 4 different positions. They can be found in various combinations of spring-centering, non-centering, detent, and pressure-release detent (eg: when cyl reaches the end of its travel, the handle pops out of detent. Good luck!
Follow Ups:
Home
| Forums
Today's Featured Article -
The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|