Posted by mark on December 10, 2008 at 08:30:56 from (172.132.152.210):
I bought an old Wards 8" Hammer mill last spring and it came with this equally old Century 3 hp, single phase, electric motor. According to an old MW ad I read, these motors were offered with the mill. It is a big bassard!
I plugged the motor in, for the first time, today. It is wired for 110 at the present and it took right off, smooth as butter. After about 5 minutes, it made a semi "clunk" noise, slowed down quite a bit and I quickly unplugged it. No smoke, not hot...no obvious signs of self destruction. I plugged it back up and it just hums and won"t start.
I am an electric motor moron and freely admit it. Even at that.....I think these repulsion start motors have some kind of start winding/clutch gizmo that starts the motor, kicks out and then serves some other function while it runs.
Whatever....it won"t start or run now. So, would some electric motor specialist please stand up and offer a suggestion as what to look for and how to fix this beast. I don"t think it is anything major...but it could be. My intention is to change it over to 230 volts for lower amp draw, if and when I put it in service. Thanks.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.