I dunno. With those things I'd never say never, but not likely it's the pump. If a pump(s) got to cavitating it would scream, but not really growl. I'm just fresh after changing the U-joints on one side of the front axle, and the noise that came from that under load before it went to pieces was best described as a deep growl. That's why I'd suggest looking at the front more... and it was felt right up to and through the foot boards.
Beyond that I'd ask if there's any trouble shifting it? What about the transfer case?
Again, probably 75% of the problems we've had with our 3930 have been FWD related. I've lost count of how many times the hubs have been apart for rings and planet gears. Also, a drive shaft problem will become much more evident at road speed than at low speeds. It will shake badly...
Hydraulics.... depends on how you have it plumbed. IF it's a dual pump model, the speed is decent, but by no means fast. If you have a loader joystick plugged into a remote, then you have a tandem center valve most likely, and you won't really get simultaneous function from that valve. If you operate the loader strictly off the remotes you should get some degree of simultaneous function from those valves if you set the flow control down somewhat. They are closed center valves... but I wouldn't expect too much if you're used to the performance of an industrial. We've got a larger pump on ours and squeeze a couple more gpm from it, but it's still not fast. It has plenty of power, but slow.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.