Posted by 135 Fan on November 23, 2008 at 17:34:57 from (24.70.95.205):
In Reply to: Re: mastercraft welder posted by bob whitmoyer on November 23, 2008 at 17:04:34:
As soon as I saw the post about a Mastercraft(Canadian tire)welder, I knew it wasn't to give a rave review. LoL I've seen the welder you're talking about. They claim it welds with 1/16 and 5/64 rods. 35 years ago puts us in the early seventies. I don't think they made these ultra cheap machines back then? Why would you drag the rod across the ground? That makes no sense. Preheating the rod would make some sense though. Stick the rod to the work for about 2 seconds and the rod will be warm. 70 amps is a little too cold for most 3/32 rods. 5/64 would be better and I think they only come in 6013? I don't know if I'd trust much with a really really economy machine like that. 7018 usually has more penetration than MIG and produces a stronger weld. MIG can be strong but on critical work, MIG isn't allowed. Back to the topic of an inexpensive welder. You would be far better to purchase a 110 volt, if that's what you need, wire feed welder and use the flux cored wire. However, I'd recommend you buy a name brand like Lincoln or Miller over a Mastercrap. Another option is a small inverter than runs DC. Princess auto had some on sale a while ago for $288, I think. 100 amps DC current. It was only about 20% duty cycle but 100 amps and DC current from an inverter would be night and day better than the Mastercrap. 100 amps would burn 3/32 rods which gives you a wider variety of rods to use including 7018 and 6010. See if you can take your machine back. You will never be happy with it and it will make welding very frustrating. Dave
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Day Mom Drove the 8N - by Brian Browning. My Dad was wanting to put in a garden but couldn't operate the 8N and handle the old horse drawn plow he had found and rigged up to use with the tractor. Well, he decided to go get Mom out of the house and have her drive the tractor while he walked behind the plow. You got to understand that while my Mom is a hard worker who will always help whenever she can... she had never operated farm machinery before that day. Dad got her out there, explained how the clutch was the same as in our o
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
