Posted by Maxine on November 15, 2008 at 04:47:45 from (24.182.74.222):
I just restored my Dad's 51 8n. It has side mt. dist. and had already been switched to 12 volt. Before it would start and run like a Singer sewing machine. But now, won't start. I replaced, wires, plugs, points, rotor, cap, condenser, coil, wiring harness & ammeter. I did not remove the dist. Getting fire everywhere but will not start even on ether. Ammeter does not move at all. Old one had stopped moving so that is why I replaced it. I took the breather pipe loose at the carb abd with the fuel shut off, sprayed ether into the carb. Plenty of suction at carb.Still will not start. Getting very discouraged. Motor was rebuilt several years ago. Has good compression. Help please!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.