Tractor Talk Discussion Board |
Re: Re: Re: Re: Re: Re: How do you figure the torque?
[ View Follow Ups ] [ Post Followup ] [ Return to Tractor Talk Discussion Board ]
Posted by terry on March 29, 2000 at 18:08:04 from (63.65.13.147):
In Reply to: Re: Re: Re: Re: Re: How do you figure the torque? posted by Dieselman on May 01, 1999 at 10:46:28:
Horsepower is a product of Torque times Speed(RPM). As rpm goes up, if torque stays the same,then HP will go up proportionlly.However, this is only a reality on paper. In the real world, engines gain torque up to a certain rpm, then start to lose torque from that point on. Some engines are designed for high-rpm applications, which don't require much torque...a weedeater is a good example. Tractor engines on the other hand, are designed for durability and high torque at low rpm's. The HP versus torque curve for a tractor engine rated 300 hp is a lot different than for a car engine. Tractor engines usaually have a long crankshaft stroke, and long connecting rods, and a tall block, which all contribute to high torque at low rpm.Car engines tend to be short-blocked, to conserve space and reduce frontal area . Therefore, a higher rpm is required to produce the same horsepower. The point where the torque and horsepower cross on the graph is the most effective rpm for getting the most useful work done. Terry
Follow Ups:
Home
| Forums
Today's Featured Article -
Restoration Story: 1951 Farmall H - by The Red (John Fritz). I have been a collector of Farmall tractors since 1990 when I first obtained part of the family farm in Eastern Indiana. My current collection includes a 1938 F20, 1945 H, 1946 H, and the recently purchased 1951 H. This article will focus on what I encountered and what I did to bring the 1951 NEAR DEATH Farmall H back to life.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|