Posted by Bill from Scotland on October 27, 2008 at 15:11:51 from (88.111.214.46):
In Reply to: engine fordson major posted by tom88 on October 27, 2008 at 06:35:28:
Hi Over here in Scotland I have seen most of the Fordson major 4 cylinder engines fitted including the industrial version. A fairly common arrangment is to fit the 6 cylinder version straight from a combine or the 360 from something like a Ford truck. Occasionally I have seen them fitted with a Perkins 6354 engine. All of the 6 cylinder versions give a usful power advantage. Alterations to the sump (oil pan) and the front axle would be necessary. We tend to reverse the front axle to have it fixed to the outside of the radiator support block. Hope this helps a little. Bill
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Proflie: John Deere Model R - by Staff. The John Deere Model R, the last of the lettered tractors, was the first diesel-powered tractor produced by John Deere with a gasoline starting engine. It was also the first tractor they produced that had an optional steel cab. The photo above shows the tractor w
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.