Posted by buickanddeere on October 15, 2008 at 06:27:50 from (216.183.136.2):
I'm trying to upgrade the starter motor size on my Dubuque Deere diesel. The more cranking power the better in winter. The block heater is usually plugged in and the tractor starts like summer. However having the ability to "cold start" is good insurance. Being in North America it's easier to find Delco starters. Trying to find a true 4KW Bosch is like trying to find hen's teeth. The current starter is a 3KW/4HP Bosch using the 2 hole mount on a 105mm spacing with a 82 or 82.5 flange mount dia. The pinion is a 10 tooth, 10/12 pitch with a pinion rest of either 35 or 38mm. The Delco 28mt snout to fit appears to be a #10457050 Deere uses variety of Delco's such as the 20mt,25mt,27mt and 28mt. None of those are any more powerful than the factory 3KW Bosch. The Delco 29mt likely will accept the same starter nose as the 28mt. However it's only 3.3KW, not much of an upgrade. Is there a two hole mount that will bolt onto the gear reduction 38mt or 39mt? Or a two hole mount for the mighty direct drive 37mt/41mt Delco's? Is there a cross reference for starter snout specs online similar to the sae flywheel/belhousing specs?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
