Bringing things up to current code is not always an improvement. Much depends on exactly what you're doing.
I've in New York and I'm sure wells vary by regions. But, at least here - I've got some experience since I've worked with a few well drillers over the past 40 years. Also have several properties with dug wells, pit-wells, and upgraded drilled wells.
Here, dug wells are - just dug wells. Pretty self-explanatory. The first drilled wells were done two ways.
One way - the casing top got buried below the frost line - 5-6 feet down. So, if the pump went bad - you had to dig it up to repair.
The other way - was to built a well-pit with a top on it - again - with the well-top below the frost line. This way, if repairs were needed, you could take the top off, go down into the pit, and work on it. Problem is - this pit can act like a funnel when the roof leaks and pollute the well.
This is the reason why modern code requires a "pitless adapter" and a buried well casing. The name "pitless" comes from its ability to eliminate the need for a pit. It enables a well to be drilled with casing installed, and a pump istalled and removed - from below the frost line - but accessed from above. It's just a brass, take-apart 90 degree valve held together by gravity.
With your well - as you describe it. If the water is still good, I have no idea why anyone wants to throw lime in there. Sounds crazy to me. If you have existing well casing down in the bottom, all you need to do is add more and extend the casing a few feet above ground. Steel or PVC. Make sure you have a pitless adapter installed, and then fill in the hole. I've done many, it's a one-day job.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
