Posted by the tractor vet on October 10, 2008 at 04:51:38 from (99.167.208.219):
In Reply to: Installing glass posted by Moline_guy on October 09, 2008 at 23:56:42:
YA put the RUBBER IN THE OPENING FIRST . THERE IS A LIP IN THE RUBBER THAT YA PULLOUT or should i say that unlocks the channel that holds the class in . Then ya set the glass in the channel and myself i use my cotterpin removal tool( it is a tool that has sorta of a pigtail on it ) i use gojo hand cleaner on the as i call it the ZIP STRIP and roll the locking channel back in . Once th glass is in the groove i can zip around the locking channel in less then a min. and the glass is locked in. JUst take some time and study the window gskt and you will see what loks like a small groove and with a small screwdriver sorta dig into that grooves and sorta lift it up and out you will see what i mean.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
