Posted by Howard H. on October 08, 2008 at 12:32:11 from (164.58.210.23):
In Reply to: Re: versitle 800 clutch posted by jack luebker on October 08, 2008 at 09:51:45:
Hey Jack -
I always have done it underneath the tractor. I just park it in soft plowed dirt and then dig out the loose dirt in the "work area" to give more room. Pretty "redneck", but worked for me.
Like I said, I've never done an 800, but from looking at them in the past, I would guess you'd even have more "wiggle room", with lighter duty components up under the cab.
We tried it from above the first time, but the dash was pretty much in the way, anyway, and I didn't want to ding anything up inside, anymore than it gets in normal usage, so we've just gone from underneath since.
Also, just FYI, a couple of times it wasn't the clutch per se, that I had to replace, but the grease hose inside the bell housing had broken loose and let it burn out the throwout bearing... So I've had to "practice" a couple of times for an otherwise preventable problem.
The worst part is that clutch assembly probably weighs 80-90 pounds and getting it placed up on the bell housing rim is the hardest part. I threw the shot put in college, though, and I've still got just enough of that conditioning to help me out... ha...
It only takes a couple of hours once you've done it a time or two...
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.