Seems if someone doesn't want components to forget (like switches) - there is nothing simpler than installing a self-exciting regulator in the alternator and using the one-wire hookup.
I don't particularly like the one-wire setup - but it does make things easy. To be technical, most of the 10SIs and 12SI will self-excite but they have to be really revving to do so (over 3000 RPM). Not practical, especially on a tractor.
If you use a conventional externally excited 10Si or 12SI and an automotive type ignition switch, you don't need a resistor or a diode to prevent run-on with the key off. Just run the excite wire to the ACC terminal, and the igntion feed (or injection pump feed) to the IGN terminal. When the key is in "off" position, ACC and IGN are isolated from each other and run-on won't happen.
That being said, it's pretty easy just to add a diode or resistor that cost less then a buck.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.