Posted by NE IA on September 30, 2008 at 16:36:43 from (206.72.18.142):
In Reply to: O/T Donkey question posted by ncdiesel48 on September 30, 2008 at 08:11:46:
I do know of a farmer that has a very large bull, and a smaller bull. This is just the way things are with mother nature. However big bull was put in a headgate and a shock collar for a dog was attatched around his haning downs. Have you ever seen a bull pull a wheeley, or slide a half mile with his gears locked up?
We decided while we were at it we could have taught him to do the dishes, but never thought of that at the time.
If you chose such a route, the person at the control tower needs to use good sence, and simply not hit the super button till he does something wrong. Probably one of the best remembered days of my adult life, even the stupid ones could probably learn fast.
The investment was very small compared to vet bills on the young bull, and the fences that he tore up before he became more sociable. He can appreciate the fact that a shock collar was probably his preferance rather than a sharp knife in the same location.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
