Tractor Talk Discussion Board |
Re: 504 ipto
[ View Follow Ups ] [ Post Followup ] [ Return to Tractor Talk Discussion Board ]
Posted by Fargo on March 07, 2000 at 18:23:34 from (12.79.0.67):
In Reply to: 504 ipto posted by REJ on March 07, 2000 at 08:15:45:
I have a 1965 IH504 gas and I had the same problem when I first got it. After some examination, I realized that I didn't need to adjust the travel of the linkage, I just needed to push the lever ALL THE WAY forward and push the worn out spring loaded locking pin into place with my hand. This is located at the bottom of the lever. Could your pin not be allowing your lever to lock all the way forward? Are you missing the pin? Try this: Push the lever all the way forward as far as it will go and hold it there. Take a look at your PTO to see if it is still spinning. If not, it is probably this pin. If it is still spinning, it sounds like your linkage. I know it sounds simple, but it fooled me for a day. Hope it's something simple. Mark
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: The Saga of Grandpa's Tractor - by The following saga is from the Tractor Talk Discussion Forum. Someone. The saga starts with the following message: Hey guys I have a decision to make. I know what you all will probably suggest and it will probably agree with me way down inside, but here it is. I have a picture blown up and framed in my "tractor room" of a Farmall M. It was my Grandpa's tractor, of which whom I never got to meet. He froze to death getting this tractor out of the barn to pull a truck out of the ditch before I was born. Anyway my dad and aunt had to sell it at the auction,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|