When we reinstall a flywheel one dude holds a sledge over on the other side up against the clutch drive disk big center bolt while the flywheel side dude armed with an oak block n hammer drives the flywheel in to her milk tight about as far as she goes, I think the spec is something like only 0.010 i.e. pretty much all the way in which reduces any excess side to side loose end play.
If shes throwing oil behind the flywheel make sure the lil pin on inner flywheel is fitting into the open slot in the oil slinger (located in the D shaped bearing/seal housing)... If the inner cork seal is bad we soak the new one in hot oil prior to installation (its in the D shaped bearing/seal housing also)
If the flywheel isnt re installed on the correct crank spline its VIBRATION CITY as its heavy side must be 180 opposite from heavy side of clutch drive disk. Torque them 2 big flywheel bolts tighter then Dicks hat band.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Engine Valves - Some Helpful Information - by Staff. Intake - On the intake stroke the piston moves doward, sucking in carburized fuel through the open intake valve. Exhaust valve is closed. Compression - With both the intake and exhaust valves closed, the pistons upward stroke compresses or squeezes the fuel into the combustion chamber. Firing - Ignited by the spark, the compressed fuel explodes and forces the piston downward on its power stroke. Intake and exhaust valves are closed. Exhaust valves and seats are exp
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.