Posted by jdemaris on September 16, 2008 at 17:59:58 from (67.142.130.13):
I cut down two large hard maples today, both close to 100 years old. My little kid had been asking about watching me cut one down, so I waited until my wife was home to hang on to him.
I've cut trees for 40 years and never used any saftey equipment - except when I worked for Asplundh and was forced to wear a helmet once in awhile when climbing. Any way, my point being I've never been hurt while wood cutting or tree felling.
Well, at my wife's insistance, I now wear a seat belt maybe 1/2 the time in the car or truck if she's in there with me. And today, wore ear protection. That's what got me in trouble. I've got new ear protectors with a built-in radio. So, I was listening to Rush Limbaugh, cutting down these trees - and . . Well, all came down fine, nice big crash for my kid. Then, all of a sudden, I had "flies" all over me and I instinctively started swatting them with my hand. Then, finally some intelligence kicked in and I realized they were not flies. I'd just cut down a bee-tree with a very active, and large hive of honey bees. If I hadn't been wearing those stupid ear protectors - I'd heard them! I yelled to my wife to grab the kid and run, and followed closely behind. We just made it back to the house, maybe 500 feet way, with the bees chasing us and bouncing off our faces. My wife got a few stuck in her hair.
I couldn't go back and get my truck or saws until dark. Funny, I've had angry squirrels, raccoons, hornet nests, etc. get in my way when tree cutting - but first time this ever happened. I suspect maybe they weren't as noticeable because it was cool today and they weren't buzzing around to much until I dropped the tree.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
