Posted by sherrmann on September 15, 2008 at 13:44:41 from (69.46.201.14):
I need some advice. I just fininshed rebuilding a 651. New pistons, sleeves, bearings and had the head redone (new valves seats, spring guides etc.) by a machine shop. It’s all back together and when I got it running there is a definite noise coming from the air cleaner. At low idle you can’t hear it, but at wide open throttle it’s almost as loud as the muffler. In addition there is no power under load. I ran it up a hill in high gear and the rpm’s just drop off. I set the timing with a timing light, right on the factory specs. I retorqued the head and adjusted the vales again. It has a new governor and when under load I can see it pull the carburetor wide open. The noise almost seems like some exhaust gases are coming through the carburetor. I was thinking that the intake manifold may have an internal crack in it allowing the gases to mix, but there is no external crack that I can see or hear. Has anyone ever seen or had this happen to them. Thanks again, Steve
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Proflie: John Deere Model R - by Staff. The John Deere Model R, the last of the lettered tractors, was the first diesel-powered tractor produced by John Deere with a gasoline starting engine. It was also the first tractor they produced that had an optional steel cab. The photo above shows the tractor w
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.