I wouldn't weld anything with gas. Absolutely nothing. That's something I learned to do 15 years ago in shop class and haven't touched since.
I learned to weld on a 225 amp Linc AC welder. Those were one tough old welder and good for basic work. It'll do what you want... If you plan on doing somewhat more welding then an AC/DC machine is nice. Right now I'm using a 225/150 amp DC Miller Thunderbolt. They're nice little welders. Either one has a 20% duty cycle though, so if you plan on getting into heavier welding you need MORE welder. The suggestions to go out and look for an old Miller DialArc or Lincoln IdealArc are well founded. Jush watch the VOLTAGE and PHASE on those things. Those were light industrial welders and as such could very easily be had in 440/550 V and various other combinations, utterly useless to you on household current... Again, if cheap is what you want, the old Lincoln AC buzz box is what you want.
Do V out the joint. It'll require a few passes for that depth. I'd do the whole thing with a 7018 rod but I've also taken to sandblasting that dirty old stuff lately. I hate using 6011's and avoid them unless I have to use them. I don't like the splatter... If you go with an AC welder, get the 7018AC rods. I don't know where you're at or what suppliers you have but I'd suggest you get a good supplier for rods. I'll run Liquid Air or BOC rods. There are cheaper ones out there like Marquette and I've nver found they worked worth a damn, especially the 7018AC rods. I had a box of them that I couldn't burn until I ran them in DC reverse on the Thunderbolt. Prax also supply a good rod from what I'm told...
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
