i'm 60 yrs old & weight 175#'s dressed: i got a 441 a yr ago, had the skidder back over it the 1st week to break it in... i really like it.. be4 that i ran a 440 to death(seals & mainbearings), & prior a 460 i got used but like new.. the 441's keep the air filter real clean, more power (little higher rpm's) new shock vibrate system (simulaar to husky) it just seams the old saws had more guts 045 & 51's, but ya got to like the new ones for speed & light weight,, we have a good dealer near & people ask me all the time what to buy & i remind them sooner or later they are going to need some parts, so buy from a local dealer that's been around. the timber cutters i know run a lot of husky's east of me but they got a big dealer over there, lots of 066's being used . mine stays in the barn it just to much saw most of the time 4 me.. i cut 4 four weeks straight last fall when our cutter got hurt, & some days go thur 2 1/2 gal of fuel.. some weeks i hardy start it but it never fails.. jew the dealer down a little or have them throw in hard hat & chaps with the new saw.. best wishes
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: The Saga of Grandpa's Tractor - by The following saga is from the Tractor Talk Discussion Forum. Someone. The saga starts with the following message: Hey guys I have a decision to make. I know what you all will probably suggest and it will probably agree with me way down inside, but here it is. I have a picture blown up and framed in my "tractor room" of a Farmall M. It was my Grandpa's tractor, of which whom I never got to meet. He froze to death getting this tractor out of the barn to pull a truck out of the ditch before I was born. Anyway my dad and aunt had to sell it at the auction,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
