Tractor Talk Discussion Board |
Re: 1940 9n ford tractor
[ View Follow Ups ] [ Post Followup ] [ Return to Tractor Talk Discussion Board ]
Posted by ltf in nc on February 29, 2000 at 17:07:53 from (206.228.213.82):
In Reply to: 1940 9n ford tractor posted by robert on February 29, 2000 at 09:18:43:
Robert, These tractors have a screen filter in the carb. The screen is accessed by carefully removing the fuel line at the brass fitting on the carb. The nut on the fuel line will round off if you do not have a tube wrench. If you do not have a tube wrench snug a pair of visegrips to the nut and loosen and then switch to an open end wrench. Once this line is loose, turn the shutoff valve on and verify that you are getting a full stream of gas. If no stream, remove the shutoff valve from the bottom of the fuel tank and unclog there. If the fuel is coming full stream from the tank then remove the brass fitting from the carb. Extreme care is required to avoid distorting the opening where the fuel line was mounted in the brass fitting. The wall on the fitting will distort if you do not use something like an adjustable wrench with thick jaws. Put a little teflon tape on the male threads on the brass fitting. The fuel line is flared and will not require thread sealant.
Follow Ups:
Home
| Forums
Today's Featured Article -
Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|