Posted by FixaLinc on September 02, 2008 at 16:35:36 from (208.246.9.39):
In Reply to: Wico magneto posted by Revredneck on September 02, 2008 at 14:18:33:
If you put a external battery ignition coil wired separate just to points and condenser fine you just converted it to a battery distributor. If like Bob said you added battery voltage to the original magneto coil congratulations you just FRIED IT ! Magnetos were designed to make their own fire not needing any kind of external battery voltage ever. That terminal on the side was only for a grounding switch to stop it. Adding battery voltage to a magneto can also ruin the magnet so no surprise if it's weaker now. If no switch or resistor to reduce voltage lucky it didn't fry off the points and condenser. Wisconsin magnetos are a dime a dozen at online auctions plenty around for parts or find another working one.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Engine Valves - Some Helpful Information - by Staff. Intake - On the intake stroke the piston moves doward, sucking in carburized fuel through the open intake valve. Exhaust valve is closed. Compression - With both the intake and exhaust valves closed, the pistons upward stroke compresses or squeezes the fuel into the combustion chamber. Firing - Ignited by the spark, the compressed fuel explodes and forces the piston downward on its power stroke. Intake and exhaust valves are closed. Exhaust valves and seats are exp
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.