Posted by T.C. in Tx on September 02, 2008 at 07:14:51 from (66.69.214.239):
In Reply to: shop air lines posted by oj on September 01, 2008 at 17:50:16:
I went through the same "what to use" exercise two years ago for my shop. Of course all the naysayers advise strongly against PVC.
My final choice was PEX--the regular stuff because it was available at the local building supply superstore along with all the fittings I needed.
It has been in service for over two years now without a hitch. I would do it again. While I have not run a consistent pressure above 110 psi, I believe it is rated up to 180 psi depending on the temperature. Since I am in central Texas, sometimes it gets hot up there near the roof where I ran a line overhead to the opposite side of the shop. I put drops below the air outlets to be sure that condensation could be drained, but I have never experienced any problems with that.
I did find that the PEX that is used for heated floors, etc. is actually rated for air service. Good luck on your choice.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Day Mom Drove the 8N - by Brian Browning. My Dad was wanting to put in a garden but couldn't operate the 8N and handle the old horse drawn plow he had found and rigged up to use with the tractor. Well, he decided to go get Mom out of the house and have her drive the tractor while he walked behind the plow. You got to understand that while my Mom is a hard worker who will always help whenever she can... she had never operated farm machinery before that day. Dad got her out there, explained how the clutch was the same as in our o
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.