Well T Bone is right.I would look hard for a used or new one.Then I would try and weld it with 7018.I just welded a cast iron pulley on a combine the other day with 7018.I veed it out,vise grip clamped a flat piece of metal on the other side,then heated with a torch kind of hot,burnt all the paint that was on it off,welded about an inch,peen,weld,peen,weld until it was finished,hit it with the torch again to where it was hot,walked away,a half hour later checked it for cracks,no cracks,no cracks the next day.
The way I told you is risky,it stands a chance of cracking,especially right beside where you weld,also in the case of your crack you need to drill a hole in the end of the crack as others said so it wont get longer.You would want to grind the top of the weld while its hot as well,I forgot to say that.When I was done with that pulley,welded in place on the combine,ground down,if you shot paint on it you wouldnt know it was there unless somebody told you.Ive done this a few times before and kind of have a feel for it.
On that case,it might be hard to hold it no matter what you weld it with.Cast iron is hard to really tell you how to weld,and very brittle.The thing is you want a good weld,dont mess around,you cant stop until you are done,and you stand a good chance it will break.T Bones method is probably the best and strongest of those mentioned here.You might want to think about taking it to a welder,but like I said to start with the best is a new or good used piece.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Engine Valves - Some Helpful Information - by Staff. Intake - On the intake stroke the piston moves doward, sucking in carburized fuel through the open intake valve. Exhaust valve is closed. Compression - With both the intake and exhaust valves closed, the pistons upward stroke compresses or squeezes the fuel into the combustion chamber. Firing - Ignited by the spark, the compressed fuel explodes and forces the piston downward on its power stroke. Intake and exhaust valves are closed. Exhaust valves and seats are exp
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
