been there, done that. its a lot of work but can be done. if you want to reuse all the material, you need to mark everything as to location and write it down.tin also, mark where each piece goes so you can reuse the old nail holes. to pull the nails off the tin, i make slide hammer pullers from pairs of long handle end nippers. get some bar stock about 3 inch in diameter, maybe 6 to 8 inches long, drill a hole thru he center so you can slide the weight over a length of 1/2 inch or 5/8 round stock, weld this to one handle of the nippers. weld a nut on the end of the rod for a stopper. to use, grasp the nail head with the nippers, and slide hammer the nail out. about 2-3 whacks will pull the nails, and it does not damage the tin. the ends of the trusses are usually bolted and nailed with 60 penny ring shank nails. wast of time to try and pull the 60 penny, just grind the heads off the nails, the truss will slip righ off them. to bring the tin down off the roof, we used a long extension ladder, pulled a tractor up near the roof with the loader up, then lay the ladder on the loader, back over the then tractor, so the back end of the ladder is behind the tractor on the ground, then slide the tin down the ladder, that way it wont bend. i didnt cut the poles off, i used a skid loader to pull the poles, shake em a little with the bucket, run water around the hole and they pull straight up. for the roof purlins, we put a couple 4x4 poles chained to the loader bucket, nail some 2x4's across so it looks kind of like a ladder, then a couple 2x4's across the top. raise the contraption up uner the end of each purlin at the truss and lift the loader, it will pop the 30 penny nails right out with the purlin.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Engine Rebuild Kit - by Curtis Von Fange. I always liked engine rebuild kits. They have all the replacement parts for overhauling an engine without going to the store to get gaskets, special measuring tools, or miscellaneous parts. They come neatly packaged, clean and tidy. But it's important not to let that packaging lull you into a false sense of security. The appearance of matching sleeves, pistons, rings, and bearings can cause frustration and agony if not properly measured and installed in a workshop environment. Following c
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.