Posted by thurlow on August 08, 2008 at 12:53:02 from (70.146.188.125):
In Reply to: info and a question posted by KEH on August 08, 2008 at 10:07:37:
Other folks have covered your hydraulic question(s); I guess they've answered your cattle prod question,also, but I'll chime in. (They don't shock, btw, at least the ones I've used; they burn). If you're dealing with cattle who all have names, I doubt that you need a 'hot shot'. I would never use one to 'drive' cattle, no matter the circumstances, but.........if you're dealing with range cattle that are only corralled/worked 2 or 3 times a year, a hot shot can be a definite asset, ONLY when she's in the chute and balks about going further.......usually just as she's about to enter the head gate. One jolt in the rear........WHEN SHE'S HEADED IN THE RIGHT DIRECTION can save a lot of frustration for you and her. There was a young lady (from Colorado, as I recall) who wrote for one of the cattle magazines a few years ago and published numerous articles about getting cattle to move forward in the chute by placing herself near their shoulder and moving backwards and forwards a couple of feet. She had extensive studies to back her up and with the right cattle, I'm sure her approach worked, but I'd loved to have seen her try it in the real world, where you've got a couple of hundred head of bawling, upset cattle who are separated from their cavles.........
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.