Tractor Talk Discussion Board |
Re: Beater Fuel economy
[ View Follow Ups ] [ Post Followup ] [ Return to Tractor Talk Discussion Board ]
Posted by Jon Hagen on February 19, 2000 at 12:19:01 from (63.160.193.141):
In Reply to: Beater Fuel economy posted by Tom from Ontario on February 19, 2000 at 09:27:41:
Tom, The first thing I would do is look at the gear ratio tag in the rear end of that truck. unless it is geared very low, like 3.50, 3.73 or 4.11. I dont know if it will ever save enough to pay for an overdrive( like gear vendors etc.) also those engines were not set up to lug at low rpm. I would check the vacuum advance and the carb power valve to make sure they are working. Both are common failures on Ford engines that are that old. normal on these trucks was 10-15 mpg If either the vac advance or power valve are blown mileage will be half of normal. Others who have owned the late 70's 351 say they pull like a 302 and drink fuel like a 460, But then compared to the cost of a new one, poor mileage on that 79 might not be so bad. Jon H
Follow Ups:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
John Deere B 1943
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|