As your field of oats starts to transform from green to that golden stage, check the actual hull of the oat to see that it has filled out. This means; in its growth stage, the hull will encompass the "milk" in the early stage, then to the "dough" in the late stage, to a full and more firm kernel. You should cut the oats at the stage of when the "dough" starts to firm up or harden. If you wait to late, the oats will shatter or seperate from the plant as you cut and swath. Also, you want to cut it early enough to prevent the plants from lodging as a result of the heavy oat heads, winds and rain. Pending varity, most oats are shatter and lodge resistant, but heavy winds and rains will knock the crop down making it difficult to cut and will decrease yield and quality. Have Fun!!!! Good oat crops in the North West should yield in a range of 80 to 130 bushels to the acre depending on soil conditions, moisture and average temperature.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.