Jerry/MT said: (quoted from post at 13:48:40 07/27/08) Are the points set correctly? I beleive it 0.015" for a front mount and 0.025 " for a side mount.Do you have a front mount distributor or a side mount? Is the timing correct? If you have a front mount there is a spring under the cap that needs to be stretched to have the correct contact. ALso make sure that the insulator that carries the primary circuit through the points is not cracked and the copper strip is not broken.
Most of the Ford N experts reside at the N Forum so you might get a quicker and better answer there.
Thanks Jerry... The points may be grounding out like you say ! the Dist is a side mount. When I say she won't fire I pulled a plug out putting it near a clean part of the frame and still no spark. I had adjusted the point to .015 still nothing. Do you think if I chance the points it will help. Since it's a positive ground.. I need to make sure there are installed correctly??? To my knowledge the so called Mech did not touch the timing.
So?? Tell me more about the points>> I have a feeling its them.. Tx van
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
