Posted by bc on July 10, 2008 at 16:39:30 from (75.27.226.227):
In Reply to: Pulling tree stumps. posted by Dan-IA on July 09, 2008 at 20:36:20:
I can think of a few people killed with chains. Last one was a few years ago. 17 yr old kid asked to go help pull his buddy out of the ditch after a night of drinking and mudding and before the cops would show up. Chain broke and went right through the back window of his pickup and in the head. Dead instantly.
Where the problem is with chains is because they have to get a running start to jerk them out of the mud and start them rolling. Back up too far and get too much jerk for the chain and it recoils from being stretched. That is why they recommend using nylon ropes/straps which allow you to jerk someone out.
When I worked in the oilfields, I've broke a few 1" winch cables (usually at the knot). It just drops the trailer/load but all the cable ever did was recoil back into a mass of coils. Nothing life threatening but we did have headache racks on the winch behind the cab. But with a winch truck we also never had to jerk on the cable either.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.