Posted by sherburne on July 06, 2008 at 04:18:31 from (75.67.79.96):
My JD410 backhoe, built in Mannheim Germany, chafed the pressure in hose to the hydrostatic unit. Couldn't find a metric bite style fitting or adapter, so I cut the hose and put a Gates jic fitting on, against most of the advice on this board. The hose was the same i.d. as Gates, and I decreased the o.d. on a lathe to Gates dimension. The din spec on the hose was higher than Gates so I didn't worry about losing a little rubber. The crimp speced out fine, and I put 3000 psi from my pressure waqsher to it. Fine. Now the problem. The hose goes to a banjo type fitting on the steering unit. JD part #AL28252. Obsolete, nla. The banjo is a cube about 1.25" that fits over a hollow threaded stud on the box. A 16mm 1.5 bolt goes over the banjo into the stud. Its 27mm hex head is under cut to create the seal. I've misplaced the bolt. Anyone know what this fitting is? Where to get one? Thanks.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Engine Valves - Some Helpful Information - by Staff. Intake - On the intake stroke the piston moves doward, sucking in carburized fuel through the open intake valve. Exhaust valve is closed. Compression - With both the intake and exhaust valves closed, the pistons upward stroke compresses or squeezes the fuel into the combustion chamber. Firing - Ignited by the spark, the compressed fuel explodes and forces the piston downward on its power stroke. Intake and exhaust valves are closed. Exhaust valves and seats are exp
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
