Posted by Leroy on June 28, 2008 at 18:52:38 from (216.201.38.18):
In Reply to: Its over posted by Lanse on June 28, 2008 at 16:26:00:
Lance, That mower was made prior to or in 1957 and sold thru the Sears Farm catalog as David Bradley was there line of equipment. The front PTO cover is not orignal but the deviding board on the outer end of the bar, the 3 rods is orignal and they were only made as a 7' mower. Some with manual lift and some with hydrolic lift. It would have had a tubular steel pitman, not a wood pitman. With manual bar lift the shipping weight was 745 pounds. And when you get it going 2nd. in either your B or C would be the correct mowing speed. And with the hydrolic lift it is one of the verry few pieces of equipment that can use a 10" or a 8" stroke hydrolic cylinder. And just use common sence and they are not dangerous, just when you raise or lower the cutter bar from horisontial to vertical keep your hands on the back side of the bar and do not touch any part of the moving part of the knife. And if everything is there the knife will not drop when lifting the bar, it will only move up to 3" to get the knife in time with the pitman to let it fold. Send me an email with your mailing address and you will get a picture out of a catalog.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
