you do have 8010 male ends correct. But even then they will do just as you have mentioned. Deal with it on daily basis assembly redo equip in my shop for dealers. You stil have to take the pressure off to get them to work easy and be installed in the bracket holders. I don't like them either. On the forklift that I use to set stuff up with I use only 9500 series lever couplers,once you do this you won't go back period. Rotate lever to release pressure to hookup and unhook under pressue they are nice. 9250-4 is model single units. 9250-4L is left hand unit yellow 9250-4R is right hand unit red these retail like $60.00 to 65.00 each or you can get complete coupling kit like I always do is retail $153.00 range. I can get at dealer cost if you would like but anyway check it out and ask for 9500-4 Coupling kit. Its worth it!!! i know these work as I have to hook and unhook stuff daily under pressure since alot of stuff out there has no safety locks to let the pressure off with in the raised position. Dultmeier handles them if you can't find anyone to help you, and you will not find them on the shelf usually just because you are going from $25.00 30.00 fitting that suppose to work to a $60-65 dollar fitting that does work. Good luck
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
